Finished write ups go here, If it is a work in progress we can transfer it here later.
I bought this intercooler a couple years ago now and finally getting it installed. At the time it was the most efficient setup. Better cooling...
Wanted to share this with you guys. Our '96 has gray leather. The front seats were pretty hard. They were Comfy to sit in but the leather was more...
So im getting to the point where im going to rebuild my engine soon and the 8th hole has been out and theres probably going to be a slight lip in...
If you have a C150 then your rear axle needs to be shifted back an inch to be recentered.Here is what i used. First i went to www.offroaddesign.com...
So, here it finally is. I'd say I am 95% done, but I figured it was enough to go ahead and post up what I've been working on in the past 8 or 9...
current dash pictures I dummied up the dash for a preview few shots of the doors progress as well
Finally got all the parts and the time to ditch the lift that was on my truck. Since I sold my Harley truck, I can't imagine trying to drive another...
As you all know we did the front reverse shackle setup. We kept the lift to a minimum. It was about 3.5" Could not decide what to do with the...
First off a big thank you to Larry P for helping me out and selling me his used Rancho arms. Great price and fast shipping. Thanks Larry. ...
So, like many ford owners, i was having surging throttle at idle from my 302 in my two door. I checked the volts on the relatively new TPS and...
So, I was messing with the Cent today, bumped up the timing a little more and turned up the pump a little more (ended up being as far as it would go,...
well I finally got pushed into working on the picador need it road worthy by june needs a new engine and transmission and front end work to be...
So, this is the quick write up for the nerf bars, it was pretty straight forward. Here's everything that came with it. Well, except the dog. ...
This thread is a pictorial reference for the removal, rebuilding, and installation of a Ford C6 Transmission. This one just happened to be mated to...
So, as I said in another thread, I got my hands on a 93 non-turbo with 135k on it. I didn't get to hear it run but I was assured it was a runner...
picked up some super swamper 37/13/15 tsl's with steel rims from craigs list for 400.00 here they are mounted on the truck. still need to repair the...
Well sort of. Hey don't laugh to hard it works :roflmao:
Here are the tease photos.
I have started my Big Fuel tank project. Quick how many cubic inches in a gallon?? I think it is 231, but could not find a conversion chart. I...
I was laying under my truck while my GF was shifting gears from drive to reverse to check where i have slack(i know that im not the only one who has...
These captions describe how to fix a leak between the ex.man. & head on a gas V8, but the technique applies to all FS Ford engines.
Due to the larger diameter tire used in the C350 Centurion was required to enlarge the depression in the Driver's rear Fender well where the spare...
I'm new to actually working on diesels, but I do have a lot of 351/350 experience. I have a 1989 7.3 Centurion. The head gasket is starting to go....
Well for starters, I knew I had a problem when pulling trailers around the mud and muck only one tire would spin. It got worse and of recent we have...
If you own a diesel, you will benefit from this, Won't help gassers much. Ford does this goofy thing, venting the gas tank through the filler neck...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules